ExaSound e28 Owner's Manual download pdf (Page 16)

Remote Control Setup

The e28 DAC is pre-programmed to work with the supplied remote control. If you like, you can

reprogram the e28 DAC to work with a different IR remote control. The exaSound e28 DAC can be

trained to recognise commands from most infrared remote controls using Sony and NEC IR protocols.

Use the following procedure to change remote control button assignments or to pair the e28 DAC with a

different remote control:

1. Power on the e28 DAC. Make sure that the unit is not in

playback mode.

2. Press the Setup button.

3. Press the Volume Up button to confirm the remote control

programming mode, or press the Volume Down button to

cancel the operation.

4. Point the remote control to the e28 DAC display. Press and hold

down the remote control buttons for about one second during

each step below to assign functions to them.

5. Press the remote control button for increasing the volume.

6. Press the remote control button for decreasing the volume.

7. Press the remote control button for selecting the next input.

8. Press the remote control button for previous input.

9. Press the remote control button for turning the unit on and off.

10. Press the remote control button for mute.

11. Press the remote control button for turning the display light on

and off.

12. Wait until the remote control configuration is saved. Your e28

DAC is now paired for use with the new IR remote control.

Page | 16

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 26 27

No comments

ExaSound e28 Owner's Manual Page 16